14.01.2021

Why do I need a valve on the battery terminal

Why do I need a valve on the battery terminal The modification of the popular lever is designed to prevent the terminal from flashing when the battery is turned off. The device is a valve on the battery terminal , and it is installed on all cars that have a battery. However, the modification should be used only if the car is equipped with an integrated circuit. The modification is not intended to prevent short circuit, if the terminals on the battery are not present together with the body. The main problem of the valve is the short circuit to the negative terminal, this can be done if the car is equipped with low-current relay on 12 Volts. If there are multiple contacts on the battery terminal, then the short circuit can be formed at the same time as the primary circuit breaker, the pinion will light, and current will flow out from the battery even if the primary circuit is turned off. The valve must be installed only if the car is equipped with a negative terminal, and only if the car is equipped with a negative terminal. In order to avoid a negative terminal from the battery, you need to install a second terminal The pinion can be any shape, including a cadence a star or a bow . The pinion can be installed independently, without installing the terminal in the battery. The pinion should be installed on the battery terminal The pinion should be installed on the terminal with a twist link. The pinion should be installed on the neck, facing the terminal, so that the pinion skin does not get in the way. If the pinion splits and the valve is torn, then the battery will run out , and even more so when the valve is replaced. Replacement of the valve If the pinion splits and the valve is torn, then the replacement will be necessary , no replacement can be performed without removing the terminal from the battery. When the pinion is torn, it is necessary to remove the wire from the terminal, and then clean the socket and pull the branch out . If the pinion is still intact and the socket is clean – solder it. It is also important to clean the edges of the body of the valve, since warping occurs in them. The edge can be up to 0.25 mm